CV boot rear Bus Vanagon 14 inch complete set with srews and grease made in Germany
CV boot rear Bus Vanagon Syncro 16 inch, fits for inner and outer
CV joint rear inclusive rubberboot and fixing material for all Bus Vanagon fits also Syncro front inner GKN / SKF Note: does not fit Syncro 16" rear drive shafts
CV joint rear inclusive rubberboot and fixing material for Bus Vanagon Syncro 16 inch. Made in Germany
Rear wheelbearing housing for all T3 2 WD and 14" Syncro. Completely rebulit ( bearing seat machined / bearing secured with special nut ) - new FAG / INA / SKF bearings fitted as well as axle stud .. so to say " plug and play ". A core deposit of 150.- EUR will be billed if you order this item and will be fully refunded if the core you sent back to us is fully useable. Most common defects are defective outer bearings seats and damaged threads of the axle stud. In these case we will be not able to ( or only partially ) refund the core deposit. You are welcome to send us your old unit up front to avoid the core deposit thing
VW T3 vanagon rear axle stud ( 100mm ) - fits all 2WD and Syncro 14" - used original part
VW T3 vanagon rear axle stud ( 100mm ) - fits all 2WD and Syncro 14" - original part
